Circuit Simulation & Automated Electrical Stress Analysis

CircuitHawk Precise is BQR’s flagship electrical stress analysis software, a unique circuit simulator for detailed stress analysis (Power, Voltage and Current) of a complete design.

Click on the topics below to learn more:

Simulation précise du stress

CircuitHawk Precise performs automated Stress Analysis for complete design in the verification (pre-layout) phase, using a circuit simulator. Accurate stress calculations are performed after the BOM freeze, providing actual operational parameters for all components in the circuit, such as power dissipation, voltage and current for a mixed signal, Analog, Digital, and RF including DC/DC power supplies.
CircuitHawk Precise uses State Vectors for analog circuits, and Bus-Simulation for digital circuits. The results serve as guidance for smart component placement based on component power dissipation.
Le calcul des contraintes électriques sur tous les composants de conception en utilisant les boucles de Kirchhoff et l'analyse de Fourier. Le calcul comprend des dizaines de paramètres selon le type de composant. Le calcul sera effectué uniquement sur la conception du produit fini et vérifiera les contraintes des composants par rapport à leurs valeurs maximales et déclassées à la température de fonctionnement et ajoutera également des considérations thermiques à la phase d'implantation.

 

Exemple:

Vérification des règles paramétriques électriques
Le type d'erreur suivant est très difficile à détecter lors de l'intégration et des tests finaux, et même par une analyse massive des causes profondes (RCA).
Surtout, l'analyste blâmera le logiciel, car rien n'est brûlé mais le produit ne fonctionne pas correctement.

Design error detected by circuit simulator

Le transistor Q1 fournit une entrée numérique à la broche 40 de U1. Elle doit être supérieure à 2,3 V pour la logique «1» et inférieure à 1,0 V pour la logique «0».

Mais Q1 fournit 1.052V, que U1 comprendra une fois comme "1" et une fois comme "0", ce qui rendra le fonctionnement non stable.

circuit simulator

CircuitHawk Generates Electrical Stress data for Thermal Analysis

One of the most important parameters for thermal analysis is the actual power dissipated in each component. This power is calculated automatically by the CircuitHawk circuit simulator and can be provided to the thermal analysis tool. Usually, this parameter is unavailable to the thermal engineer and that is why he uses the maximum value of the components power from the datasheet. In this case, these results are the worst case and if we use them we will create over-design such as over-cooling or taking components with higher rating values (which may be desirable), but sometimes it increases the cost and the physical size of the product unnecessarily.

CircuitHawk Generates Electrical Stress data for Reliability Physics (Physics of Failure) Predictions

The product Reliability is measured by the MTBF according to different standards or by the Failure Rate distribution in time using the Physics of Failures method. These calculations are strongly influenced by the stress of each component. In this case, CircuitHawk provides the exact stress and consequently the reliability calculation is more accurate.

Want to learn more?