Circuit Simulation & Automated Electrical Stress Analysis

CircuitHawk Precise is BQR’s flagship electrical stress analysis software, a unique circuit simulator for detailed stress analysis (Power, Voltage and Current) of a complete design.

Click on the topics below to learn more:

정확한 스트레스 시뮬레이션

CircuitHawk Precise performs automated Stress Analysis for complete design in the verification (pre-layout) phase, using a circuit simulator. Accurate stress calculations are performed after the BOM freeze, providing actual operational parameters for all components in the circuit, such as power dissipation, voltage and current for a mixed signal, Analog, Digital, and RF including DC/DC power supplies.
CircuitHawk Precise uses State Vectors for analog circuits, and Bus-Simulation for digital circuits. The results serve as guidance for smart component placement based on component power dissipation.
설계된 부품들에 대한 전기 스트레스 계산에서는 Kirchhoff 루프 및 Fourier 분석을 사용합니다. 이 계산은 부품유형에 따른 수십 개의 변수를 포함합니다. 또한 이 계산은 완제품 설계에서만 수행되며, 동작온도에서 최대 및 경감된 rating 대비 부품의 스트레스를 확인하고, 레이아웃 단계에서 열적 요소를 추가적으로 고려합니다.

 

사례:

1) 전기적 변수 규칙 검사
다음 유형의 오류는 통합 및 최종 테스트 중에, 심지어 대규모 RCA (근본 원인 분석)에 의해서도 검출하기가 매우 어렵습니다.
대부분의 경우 분석가는 소프트웨어를 비난 할 것입니다. 왜냐하면 아무것도 태워지지 않았지만 제품이 제대로 작동하지 않기 때문입니다.

Design error detected by circuit simulator

트랜지스터 Q1은 U1의 pin 40에 디지털 입력을 제공합니다. "1"로직의 경우 2.3V 이상, "0"로직의 경우 1.0V 미만이어야 합니다.

그러나 Q1은 1.052V를 제공하는데, U1은 한 번은 "1"로 이해하고 한 번은 "0"으로 이해하여 기능이 불안정할 것입니다.

circuit simulator

CircuitHawk Generates Electrical Stress data for Thermal Analysis

One of the most important parameters for thermal analysis is the actual power dissipated in each component. This power is calculated automatically by the CircuitHawk circuit simulator and can be provided to the thermal analysis tool. Usually, this parameter is unavailable to the thermal engineer and that is why he uses the maximum value of the components power from the datasheet. In this case, these results are the worst case and if we use them we will create over-design such as over-cooling or taking components with higher rating values (which may be desirable), but sometimes it increases the cost and the physical size of the product unnecessarily.

CircuitHawk Generates Electrical Stress data for Reliability Physics (Physics of Failure) Predictions

The product Reliability is measured by the MTBF according to different standards or by the Failure Rate distribution in time using the Physics of Failures method. These calculations are strongly influenced by the stress of each component. In this case, CircuitHawk provides the exact stress and consequently the reliability calculation is more accurate.

Want to learn more?